Welding Application Guides

When Does a Welding Robot Need Laser Seam Tracking?

Compare seam finding before welding with laser seam tracking during the weld. Learn how joint position, fit-up gaps and fixtures affect the choice.

Discuss seam finding and tracking requirements

If the joint starts in a different position on each part, seam finding can help the robot locate it before welding. If the joint moves as the weld progresses, a suitably configured laser seam tracking system can measure its position and guide the torch along the joint. Start by checking when the variation occurs.

The first part is set up correctly, but the next sits slightly differently. Will the robot miss the weld? This needs answering before choosing an automated welding system.

A robot can repeat a programmed motion, but the actual seam may move between parts. Without sensing and compensation, a fixed path may no longer match the joint. First establish the cause of the variation.

Has the position changed, or has the joint changed?

An offset part, dimensional variation, inconsistent fit-up gaps and distortion during welding are different problems.

A shifted seam and a wider gap between plates do not necessarily need the same remedy. The former may require a path correction; the latter may also require better fit-up or changes to the welding procedure.

Seam finding or seam tracking: which fits my part?

What you see on the shop floorWhat to check first
The joint starts a few millimetres to one side on the next part.Check how the part sits in the fixture. If the offset remains, test whether seam finding can locate the joint before the arc starts.
The seam moves as heat builds during the weld.Test tracking on representative parts. The sensor must see the joint and the torch must be able to follow the corrected path.
The gap between the two pieces varies.Check edge preparation, clamping and the welding procedure. Correcting torch position alone does not correct an excessive gap.

Detection sequence, recognizable joint shapes and compensation range depend on the sensor, software, robot and welding system. Validate them on representative parts.

Laser seam finding is not laser welding. One uses laser light to measure position; the other uses a laser as the welding heat source. A laser-guided cell may still use arc welding.

Can tracking replace fixtures?

Suitable locating and clamping are usually still required. Sensing has limits and cannot replace every fit-up requirement.

Fixtures also hold the relationship between parts and prevent movement. Check fit-up and location first, then assess whether the remaining variation needs finding or tracking.

Evaluate joint geometry, surface condition, torch clearance and samples with actual variation. A feature list saying tracking supported is not enough.

Published application reference

DUCO describes several GCR5-910 cobots welding door panels and frame components. In that application, laser sensing locates the seam and can guide corrections to the welding path, depending on the system configuration.

View the original case and resources

The source does not specify permissible deviation, sensor model or welding parameters. Finding and tracking require the appropriate configuration; the robot model alone does not confirm those capabilities.

A WeldVanta application guide. Referenced third-party projects were not delivered by WeldVanta. Configuration and results require assessment of the actual workpiece.

Explore related products

Does your workpiece need seam tracking?

Tell us whether the offset is present before welding or develops during the weld. Include the joint type, material thickness and typical fit-up gap. To send drawings or workpiece photos, use the WhatsApp number on our contact page.

Contact WeldVanta

The form is loading. If it does not become available, you can contact us on WhatsApp.